Despatch Protocol Plus Controller (Heat Only) Manual do Utilizador descarregar pdf (Página 43)

Protocol Plus Owner’s Manual OPERATION

Version 2 43

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

Table 13. Enable Page Parameters and Values.

Menu Item

Display

Description

Range

Profiles

Enable Profile

1-8

Controls access to Program

Page

Yes or No

Autostart

Enable Auto

Start

Controls access to AutoStart

Page

Yes or No

PID

Enable PID

Controls access to PID Page

Yes or No

Control

Enable Control

Controls access to Control

Page

Yes or No

Communication

Enable

Communication

Controls access to

Communication Page

Yes or No

Real Time

Clock

Enable Clock

Controls access to Real Time

Clock Page

Yes or No

Relay outputs

Enable Relay

1-4

Controls access to Relay

Page

Yes or No

Test

Enable Test

Controls access to Test Page

Yes or No

Zone

Calibration

Enable Zone

Cal

Controls access to Zone

Calibration Page

Yes or No

Sensor

Calibration

Enable Sensor

Cal

Controls access to Sensor

Calibration Page

Yes or No

Setpoint lower

limit

Enable

SPLowerLim

Sets minimum setpoint

allowed

-73°C to 759°C (-100°F to

1399°F)

Setpoint upper

limit

Enable

SPUpperLim

Sets maximum setpoint

allowed

-73°C to 760°C (-100°F to

1400°F)

High limit

overhead

Enable

HiLimOH

Sets maximum high limit

setpoint allowed

3 to 11°C (5 to 20°F)

Password level

Enable

Password 1

Sets password for access

level 1

0 to 999

Password level

Enable

Password 2

Sets password for access

level 2

0 to 999

Setpoint

Change

Enable

SPChange

Set to DISABLE to lock out

setpoint and high limit

setpoint changes in Manual

and Timer Modes

Yes or No

Analog Output

Type

Enable Analog

Type

Sets Analog Output type

Ctrl or Proc

5.6.12. Setting up Digital Inputs (Optional)

The Protocol Plus control can be run by external inputs wired to the control from an

external source such as a PLC or control panel switches (Figure 9). The external run

operation can Run, Hold or Stop profiles 1 through 7 (profile 8 cannot be operated

externally). See Table 14 for the inputs required for the desired operation.

If the controller does not have this feature, No is the only option.

Maximum high limit setpoint = SPUpperLim + HiLimOH

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 55 56

Comentários a estes Manuais

Sem comentários

Despatch Protocol Plus Controller (Heat Only) Manual do Utilizador Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Painel de controlo Despatch Protocol Plus Controller (Heat Only)