Despatch Protocol Plus Controller (Heat Only) Manual do Utilizador descarregar pdf (Página 36)

OPERATION Protocol Plus Owner’s Manual

36 Version 2

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

Table 7. Communication Page Parameters and Values.

Menu Item

Display

Description

Range

Address

Communication

CommAddr

Sets address node for

control

1 to 247

Mode

Communication

Comm Mode

Turns on/off

communications

OFF, Modbus

Baud Rate

Communication

Baud Rate

Sets interface speed

2400, 4800, 9600,

19.2K, 38.4K

Parity

Communication

Parity

Sets parity for interface

None, Odd, Even

5.6.8.2. Setting up the Real Time Clock Page

The real time clock is a seven day, 24-hour clock with battery backup. The Real Time

Clock Page allows an operating mode to begin automatically at a specific time on a

specific day of the week. The real time clock feature also for use of the Power Failure

Recovery mode Time Limit feature (see Setting up the Control Page Section 5.6.7). Table

8 shows the menu items available.

5.6.8.3. Access Real Time Clock Page

1. Enter Setup Mode.

2. Press

Page until Clock displays.

3. Press

Menu.

4. Change each parameter by pressing Menu until the desired parameter is displayed,

and then press ▲ or ▼ to change the value.

Table 8. Real Time Clock Page Parameters and Values.

Item

Display

Description

Range

Day of the

week

Clock

Day

Setting for current day of the

week

Sun, Mon, Tue, Wed, Thu, Fri,

Sat

Time of

day

Clock

Hh:mm

Setting for current time of the

day

00:00 to 23:59

Reset

clock

Clock

UP to Reset

Press the

▲

key to set the

clock to entered values

Ready, Done

5.6.9. Setting up the Relay Outputs Page

The Relay Outputs Page configures the four alarm/event outputs. Each output has a

dedicated indicator light and can be configured as a temperature alarm, profile event, or

end of cycle output. Temperature alarms can be of type process high, process low,

deviation high, deviation low, or deviation band. Table 9 shows the menu items available.

If the ▲ key is not pressed, clock values retain original values. The display changes to Done if the clock

is reset.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 55 56

Comentários a estes Manuais

Sem comentários

Despatch Protocol Plus Controller (Heat Only) Manual do Utilizador Página 36

Comentários a estes Manuais

Manuais e produtos relacionados com Painel de controlo Despatch Protocol Plus Controller (Heat Only)