Despatch MIC1462 Controller Quick Start Manual do Utilizador

REV. 8-02 P.N. 211142 MIC 1462 1/4 DIN SETPOINT PROGRAMMER QUICK START USER MANUAL Copyright © 2002 by Despatch I

8 STEP DESCRIPTION MESSAGE DISPLAY FUNCTION AVAILABLE SETTING 5 Program Lock LockProg Defines whether the operator is permitted to change prog

9 Program Parameters (apply as a whole to a specific program) (Program Number = 1 to 8, Segment = Blank) 1. Press the mode key until the message d

10 STEP DESCRIPTION MESSAGE DISPLAY FUNCTION AVAILABLE SETTING 7 Start Time** Strt-ti Determines the automatic start time for the profile 1:00 -

11 Segment Profile Parameters Table STEP DESCRIPTION MESSAGE DISPLAY FUNCTION AVAILABLE SETTING 1 Final Setpoint Value Final SP Defines the fin

12 Exiting Profile Set Mode The operator may exit from Profile Set Mode by pressing the MODE key. To return to Base Mode, press the MODE key until

13 Entering Global Parameters For The Profile Press the mode key until Prof Par is displayed in the Message Display. Press the SCROLL key and Cycl

14 Running The Profile Press the PROF key until 1 is displayed in the Program Display. Press the Run/HOLd key until 1 is displayed in the Segment

TABLE OF CONTENTS POWER UP PROCEDURE... 1 KEYPAD OPERATION.

1 POWER UP PROCEDURE Verify all electrical connections have been properly made before applying power to the instrument. If the instrument is being

2 DOWN Key Decrements displayed parameter value/cycles through options. PROF Key Cycles through Program (profile) numbers. RUN/HOLD Key Runs,

3 INDICATORS Control Status Indicators AT - On when Self-Tune is active; flashes when PreTune is active. ALM - Flashes when any alarm is active.

4 Mode Indicators SET - On when Profile Set Mode is entered; flashes when viewing parameters in Configuration Mode after entry from Base Mode. PR

5 Single Setpoint/Base Mode Control With the Setpoint Programmer in Base Mode (i.e. with the RUN, HLD, SET, and PRG indicators off), the two main d

6 indicator will go on continuously. When the operator removes the manual Hold (by pressing the RUN/HOLD key again), the HLD indicator will either

7 MIC 1462 PROFILE PROGRAMMING Programming a profile into the MIC1462 control is broken into three categories: GLOBAL - Those parameters common to