Despatch MIC1462 Controller Manual Manual do Utilizador descarregar pdf (Página 54)

Now, with Program 2 set to perform 10 cycles, change its last segment to a Repeat

segment (Segment Time or Ramp Rate set to REP); the result would be:

At the end of the tenth cycle of Program 2, the program sequence would end.

6.6 Basic Rules To Remember

In any program sequence:

• A program ending in a Join segment will perform the required number of cycles of

itself before joining the new program.

• A program ending in a Repeat segment (hence, by definition, the last program in the

sequence) will perform the required number of cycles of itself before ending the

sequence.

• A program ending in an End segment (hence, by definition, the last program in the

sequence) will perform its cycle on the entire program sequence before ending that

sequence.

6.7 Exiting Profile Set Mode

The operator may exit from Profile Set Mode by pressing the MODE key. To return to

Base Mode, press the MODE key until the Base Mode prompt appears in the Message

Display, then press the SCROLL key.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 111 112

Sem comentários

Despatch MIC1462 Controller Manual Manual do Utilizador Página 54