Despatch MIC1162 Hi-limit Manual do Utilizador descarregar pdf (Página 15)

RTD Input

Make RTD connections as illustrated below. For a three wire RTD, connect the

resistive leg of the RTD to terminal 6 and the common legs to terminals 4 and 5. For a

two wire RTD, connect one leg to terminal 5 and the other leg to terminal 6 as shown

below. A jumper wire supplied by the customer must be installed between terminals 4

and 5. Input conditioning jumper must be positioned correctly (see Appendix A) and

Hardware Definition Code must be correct (see Appendix B).

FIGURE 2-10

Volt, mV Input

Make volt and millivolt connections as shown below. Terminal 5 is positive and terminal

4 is negative. Input conditioning jumper must be positioned correctly (see Appendix A)

and Hardware Definition Code must be correct (see Appendix B).

mADC Input

Make mADC connections as shown below. Terminal 4 is positive and terminal 6 is

negative. Input conditioning jumper must be positioned correctly (see Appendix A) and

Hardware Definition Code must be correct (see Appendix B).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

Sem comentários

Despatch MIC1162 Hi-limit Manual do Utilizador Página 15